| ADSL/2+ Compliance | |
| • ADSL standard ITU G.992.3 Annex A (G.dmt.bis) / ITU G.992.5 Annex A | |
| • ADSL Maximum Rate: 12 Mbps for downstream and 1 Mbps for upstream | |
| • ADSL2+ Maximum Rate: 24 Mbps for downstream and 1.2 Mbps for upstream | |
| • Support dying gasp | |
| ATM Features | |
| • Compliant to ATM Forum UNI 3.1 / 4.0 Permanent Virtual Circuits (PVCs) | |
| • Support up to 16 PVCs for UBR, CBR, VBR-nrt, VBR-rt with traffic shaping | |
| • RFC2684 LLC Encapsulation and VC Multiplexing over AAL5 | |
| • RFC2364 Point-to-Point Protocol (PPP) over AAL5 | |
| • RFC2225 Classical IP and ARP over ATM | |
| • RFC2516 PPP over Ethernet: support Relay (Transparent Forwarding) and Client functions | |
| • Support PPPoA or PPPoE Bridged mode | |
| • OAM F4/F5 End-to-End/Segment Loopback Cells | |
| Bridging Features | |
| • Supports self-learning bridge specified in IEEE 802.1d Transparent Bridging | |
| • Supports up to 4096 learning MAC addresses | |
| • Transparent Bridging among 10/100 Mb Ethernet ports and | |
| wireless LAN | |
| • Supports IGMP Snooping | |
| • Supports 802.1Q VLAN packet pass-through | |
| Routing | |
| • DHCP Client/Relay/Server | |
| • DNS Relay and embedded DNS server | |
| • Static routes, RFC1058 RIPv1, RFC1723 RIPv2, Source Routing. | |
| • ALGs (Application Level Gateways):, VPN pass-through with multiple sessions, SIP, etc. | |
| • Support Port Forwarding; Port Triggering; DMZ host; DDNS; Static DNS; | |
| • UPnP IGD (Internet Gateway Device) with NAT traversal capability | |
| • Time protocol can be used to get current time from network time server. | |
| • Support IGMPv1/v2/v3 Proxy | |
| • Support QoS for prioritize the transmission of different traffic classes | |
| • Support port mapping function; | |
| • Support 802.1Q VLAN Tagging on egress WAN interface | |
| Configuration and Management | |
| • Telnet/HTTP/SSH for local or remote management | |
| • Configuration file backup and restore | |
| • Support TR-069 and TR-111 Part 1 | |
| Hardware Interface | |
| • One RJ-11 port for ADSL connection | |
| • Four RJ-45 ports for IEEE 802.3/802.3u 10/100 Base-T auto-sensing and auto-crossover | |
| • One hidden button for restoration of factory default settings | |
| • One push button for WPS PBC support | |
| • External power adapter 12VDC/1.0A (output) | |
| Wireless LAN | |
| • Supports IEEE 802.11n (draft 2.0), IEEE 802.11g and IEEE 802.11b | |
| • Data Rates: Up to 300Mbps for 802.11n, up to 54Mbps for 802.11g and up to 11Mbps for 802.11b | |
| • Antenna Configuration: 2 fixed external antennas (2T2R) | |
| • RF Output Power: 15±1.5 dBm in 2.4 GHz | |
| • Coverage Area: Up to 300 metres1 | |
| • Operating Frequency: 2.412 ~ 2.484 GHz | |
| • Operating Channels: 13 channels (Australia) | |
| • Support 802.1x, WPA/WPA-PSK, WPA2/WPA2-PSK, Mixed WPA/WPA2, and Mixed WPA-PSK/WPA2-PSK | |
| • Supports multiple SSIDs | |
| • Supports wireless QoS (WMM) | |
| • Support WEP (Wired Equivalent Privacy) RC4 with 64-bit or 128-bit key length | |
| • Support Access Control List, only registered WLAN clients are allowed | |
| • Supports wireless protected setup (WPS) with PIN and PBC method | |
| • Support repeater function to extend coverage (WDS) | |
| • Support client isolation for wireless hotspot | |
| ENVIRONMENTAL CONDITIONS | |
| • Operating temperature 0 ~ 40°Celsius | |
| • Relative humidity 20 ~ 90% (non-condensing) | |
| DIMENSIONS | |
| • 190 mm (W) x 30 mm (H) x 150 mm (D) | |
| • Weight: 320g | |
| |
